Mickey skeleton Led Lamp Same Layer
Copyright Claim
Mickey skeleton Led Lamp Same Layer
Boost
49
43
4
Print Profile(1)
best settings / fast print 0.2mm layer, 2 walls, 15% infill
3.6 h
2 plates
Boost
49
43
4
0
80
29
Released
Description
Halloween made in different colors on the same layer. By adding a strip of LEDs, you will get a lit effect.
Comment & Rating (4)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
toller Druck aber leider fehlt ein Ausgang für das Kabel
The designer has replied
0
Reply
Hello, I didn't leave a cable outlet for each person to change and place the slot as they see fit. As a rule, I use USB type C. If it is for a simple cable, it is simple to make the hole
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great image. Walls and back plate are a bit thin.
0
Reply
Congratulations on all your models, very well made and they all fit the bill. congratulations
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld