No Print Profile yet. Add one to earn points.
Aluminum extrusion based sim racing rig mount for an Apple iPad 2. This is a remix of https://www.thingiverse.com/thing:550592.
Made for 8040 extrusions with 8mm slot. Designed to be used with the M6x12 screws and T-nuts that come with the SimLab P1-X cockpit.
The very old iPad 2 works good enough with SimHub dashboards (web-based/Safari) to give it purpose again (in 2022+ ;-)).
Note: The remix design is a bit flawed: Actually sliding the iPad in is a bit tricky ... do not expect to get it out of the mount regularly. I would love to see a remix that separates the extrusion mount from the case again and comes up with some sort of "slide-in" mechanism.
Printer Brand:
Creality
Printer:
CR-20
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
10%
Filament:Creality PLA Black
Notes:
Make sure to reduce the support density to about 8% or less. I used 8% gyroid pattern and a brim. Took about 10 hours per half.