Eufy C120 Front Glass Mount
Copyright Claim
Eufy C120 Front Glass Mount
Boost
20
51
13
Print Profile(1)
0.08mm layer, 2 walls, 20% infill
Designer
2.1 h
2 plates
Boost
20
51
13
0
60
67
Released
Description
You need to remove the Stand of the Eufy C120. It´s very easy.
Easy to glue on the Glas with small double sided glue tape.
Comment & Rating (13)
All
Print Profile
0.08mm layer, 2 walls, 20% infill
Great
(Edited)
1
Reply
Print Profile
0.08mm layer, 2 walls, 20% infill
Came out really nice! Thanks
Don’t make the same mistake and leave the SD card in when you open the camera, it will likely bend the tray that it sits in 😵
1
Reply
Print Profile
0.08mm layer, 2 walls, 20% infill
The print was flawless
0
Reply
Great stuff slotted together easy pzy.
0
Reply
OK, I must be a dummy, I was able to get the plastic stand off, but what about the metal piece that protrudes from the camera?
0
Reply
Print Profile
0.08mm layer, 2 walls, 20% infill
1
Reply
Print Profile
0.08mm layer, 2 walls, 20% infill
1
Reply
Print Profile
0.08mm layer, 2 walls, 20% infill
1
Reply
Print Profile
0.08mm layer, 2 walls, 20% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 20% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld