This is a simple drone racing frame meant for common components and should be printed out of a strong or rigid substance like abs, carbon fiber enlaced pla, or nylon. It has a top mount that will go on top of any height of standoffs that has holes to attach a batter onto, and an fpv mount that I used specifically for my runcam which had lost its mounting hardware a while ago. This fits all 2200 sized brushless motors and is meant to be used with 5-inch propellers. I have not been able to test this fully out in the field, so use this at your own discretion and responsibility.
If you have any questions or need a redesign suited to your specificities, feel free to message me here or on Reddit, @hackerwithalacker
Printer:
CR10S PRO
Rafts:
No
Supports:
No
Resolution:
.15
Infill:
65
Filament: hatchbox abs red
Notes:
use 5+ perimeter lines and plenty of top/bottom layers. Strength is key in this design.