Jewellery Tree

Copyright Claim

Jewellery Tree

Boost
10
6
4

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 5% infill
0.2mm layer, 2 walls, 5% infill
Designer
2.7 h
3 plates
4.0(2)

Boost
10
6
4
1
19
13
Released

Description

This is a tree meat to hold jewellry pices or anything that strikes your fancy.

Comment & Rating (4)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 5% infill
sehr schöne Vorlage eine kleine Kritik wäre bei den Verbindungspunkten der einzelnen Teile der Baumkrone eine kreuzüberblattung zu machen oder einen kleinen Dübel als Fixierung zum verkleben ansonsten top👍
(Edited)
The designer has replied
1
Reply
fixed this after your comment but dint say it any thing.
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
Bed Adhesion Issue:come out allright had to put glue down and part Still didn't stay down for the print
The designer has replied
0
Reply
I guess you're referring to the tips they can come up a bit of the plate for me, but in my case it was barely noticeable. Can you tell me if the connections of the branches came out ok? I never ended up reprinting this.
0
Reply
No more