Festool Systainer front handle DIY
Copyright Claim
Festool Systainer front handle DIY
Boost
16
25
12
Print Profile(1)
0.16mm layer, 4 walls, 20% infill
1.3 h
1 plate
Boost
16
25
12
0
37
18
Released
Description
I made this handle to get your "older" systainer out of your car or cabinet.
Just make two holes in the front and screw the two foots on the front.
Hardware needed:
M4 Nuts en screws
You can sell our designs we made and are available on our makerworld page. Wit a small sub on our Patreon you get a commercial license to sell and back our non profit founding for Children with special needs: https://www.patreon.com/wickieprints/posts
Comment & Rating (12)
All
Print Profile
0.16mm layer, 4 walls, 20% infill
Merci pour le partage 👍
les supports sont durs à enlever.
0
Reply
Hello, Do you have these handles available for purchase? Thank you
The designer has replied
0
Reply
YEs i have. But i'm from the Netherlands so don't know if that is a problem?
0
Reply
Replying to @NickR1983
Hello, Wonderful. I suspect they will ship just fine by international post. I am not in any hurry. How can I go about ordering these? I would like to order 10. Thank you
0
Reply
Can you tell us which filament have you used? is a perfect match of the original color
thank you!
The designer has replied
0
Reply
Hi TinyWorkshop, Yeahsure. It's a PLA from a local (EU, Netherlands) based shop. It's their housebrand and the color is yellowgreen: https://www.123-3d.nl/123-3D-Filament-geelgroen-1-75-mm-PLA-1-1-kg-Jupiter-serie-i9683-t7322.html
Hope it helps you a little bit.
0
Reply
Replying to @NickR1983
Many thanks :)
and Merry Christmas!
0
Reply
Replying to @TinyWorkshop
Same to you. Happy holiday!
0
Reply
Print Profile
0.16mm layer, 4 walls, 20% infill
1
Reply
Print Profile
0.16mm layer, 4 walls, 20% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution
© 2024 MakerWorld