Search models, users, collections, and posts
Snap Hook Fastener
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Increased load capacity, 0.16mm layer, 3 walls, 100% infill, PLA
3.6 h
1 plate
Open in Bambu Studio
Boost
26
64
13
3
67
39
Released
Description
We keep a plastic bag on the back of a cupboard door purely to store plastic bags, crisp packets to recycle, this bag was always falling off so I thought I would remedy this problem by the way of this simple hook fastener.
Its about 80mm long and has a countersunk hole for a screw.
It does a job so to speak so I thought I would list if for others to use.
Prints on its side with no support.
Thannks for Looking
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (13)