Round 2 baby! My second 3d print design and something a bit more fun. I wanted to make something simple and fun while also being somewhat unique. This is my second version of this design as the first one did not bite hard enough for my liking. I must say that I did take inspiration from @muzz64 for the idea of a shark clip, but I wanted to put my own twist on it by giving the hammer shark some love and attention!

Link to @muzz64 and his page: https://makerworld.com/en/@muzz64 

Print Settings:

I used Cura as my slicer, an Ender 3 V2 as my printer, and utilized the following settings:

Filament: PLA
Quality: Standard (0.2mm)
Infill: 100% (I would imagine you could get away with maybe 60-70% but no guarantees)
Infill Pattern: Gyroid
Support: Tree
Adhesion: None

As for how to position it, the wide mouth does make it a bit awkward to lay flat on its side, so I believe tree supports are a necessity. 

I hope it turns out well for you guys, and again any feedback on how to improve my models would be greatly appreciated. I will continue to improve!