this is a work in progress, please feel free to leave a comment or message me about any changes that you feel should be made to this model.

I coudlnt find any decent front sights to print so i decided to make my own and its roughly based on an existing design. This is still the V1 and if theres any changes that people think I should make then ill be more than happy to hear about it.

as this is just a 3d printed part, these arent intended for use with real pew pews but more if you dont want to pay $200 for just the front sight from KAC for airsoft pew pews. theyre really more for looks but im sure theyll be fine if you need them in a pinch.

printed with Inland PLA+
nozzle temp 200
bed temp 70
layer height .20
nozzle size .6
3 walls
(i added fuzz to make the exterior to look a bit better 0.2, 1.25, 0.3)
cubic infill at 30%, could be even less if you want to try experiment with it

print with supports

print both facing down as shown in pictures.

using an m4 screw to thread into the hole and using an m4 nut to secure it at the end is recommended but the nut isnt required as the from the fuzz the screw stays in securely.