Summary

This is a standalone adaptation of my CadetThrottle Module!

!!!IMPORTANT!!!
There are a few slight changes in this version compared to the module version. PLEASE follow these changes or your knob will not work!

CHANGES:
Straw length: 210mm
Straw hole distance (from the rear): 94.7mm
New potentiometer form factor:
----Travel: 100mm
----Mounting Hole Distance: 120mm
----Slide Shaft Width: 8mm
----Similar to these: https://www.amazon.com/IIVVERR-Potentiometer-Potenci%C3%B3metro-deslizante-Terminales/dp/B08LDV6FF4/ref=sr_1_4?dchild=1&keywords=100mm+slide+potentiometer&qid=1605547511&sr=8-4

You will also need to drill two additional M3 holes in your mounting surface to align with the 2 M3 holes on the front of the base.

Other than these changes, follow the rest of the build guide here:
https://youtu.be/W6DysglXp-0

Print Settings

Printer Brand:

Prusa

                                            Printer:                      
i3 MK3

Rafts:

                                            Supports:                      
Yes

Resolution:

0.2

                                            Infill:                      
15%

Filament:

Overture PETG

                Black                    
                        Notes:                     
The sheath should be printed thread-side up using a brim to secure it firmly to the build plate.rnrnThe knob and push-button should be printed face down with support under the overhang circles.rnrnThe end cap is a rotary joint that prints in place.  Use needle-nose pliers to break the joint free.