Vertical Foregrip

Vertical Foregrip

Boost
4
7
0

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 25% infill, no support, 2 variants
0.2mm layer, 2 walls, 25% infill, no support, 2 variants
Designer
3 h
2 plates

Boost
4
7
0
0
8
8
Released

Description

Vertical Foregrip

Description

The first of my paintball marker attachments. This model has been designed to work with picatinny rails. It has been tested on the Planet Eclipse EMF100 marker.

Printing

Usually, although there are a few overhangs, supports are not required for a successful print. I have printed the foregrip pieces with default settings and no supports. All pieces should be printed as shown in the image below; the 3mf file is included with the correct orientations.

 

Additional Parts

4x M3 Screws with a minimum length of 20mm

4x M3 Hex Nuts

 

Total list:

  1. Grip Clamp
  2. Grip Body
  3. M3 Nut Holder
  4. 4x M3 Screws
  5. 4x M3 Hex Nuts

 

Assembly

Full assembly video:

Step 1: Insert M3 nuts into the holder.

All of the nuts should just fall into place.

Step 2: Insert the holder (with the nuts) into the grip body.

You should hear a click or two when it's in. The holder will not be entirely flush with the body of the grip and should be a little lower.

Step 3: Mounting

Place all the screws loosely through the grip clamp and into the body. They just need to hold until you can get the grip onto the rails.

Once the grip is loosely in place, all you have to do is tighten the screws and you're done!

Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more