P1P Screw on Chute Remix
Remixed by
Copyright Claim
P1P Screw on Chute Remix
Remixed by
Boost
31
26
3
Print Profile(1)
0.2mm layer, 3 walls, 100% infill
Designer
7.4 h
1 plate
Open in Bambu Studio
Boost
31
26
3
0
64
10
Released
Comment & Rating (3)
All
The poop chute has a gap on the P1P without panels, is there a part I'm missing?
Also, what kind of screw did you use? The screw above the poop chute exit is not long enough for this print.
Please reply, as I've wasted half a roll of filament printing two of these for my P1P's. I'd like to use them.
(Edited)
The designer has replied
0
Reply
sorry, no you're not missing parts. it's just 1 piece and a screw.
the chute was for my p1p when I had a printed enclosure on it, I'm sorry the gap is troubling you but that's probably what is affecting it. this was a rookie design for me and I didn't take much into consideration before uploading (ie no instructions, examples or more pictures) the screw should be m3 x 15mm.
(Edited)0
Reply
Print Profile
0.2mm layer, 3 walls, 100% infill
0
Reply
No more
Related Models
© 2024 MakerWorld