Print Profile(1)
0.2mm layer, 1 walls, 0% infill
Designer
2.9 h
1 plate
Open in Bambu Studio
Boost
54
99
41
0
315
236
Released
Comment & Rating (41)
All
2 walls, 3layer bottom. bottom is thin, printed with DO3D PLA SILK Rainbow
The designer has replied
1
Reply
i like it! nice color👍✌️
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
This came out beautiful, but like others I had trouble with the bottom peeling off. I made the bottom a little thicker and it stayed, but was still unable to hold water. otherwise an amazing and impressive piece.
1
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
very fragile, bottom is like tissue paper.
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
walls were too thin. I’m new- is that something in the profile? I would think so, but not sure.
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
base layer too thin. ripped off when removing brim.
The designer has replied
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
When I removed the vase, it broke off from the bottom, but the main part looks great.
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
looks very nice, but it is not holding water, also the bottom broke of from the rest by loosing it from the pei plate!
0
Reply
0.2mm layer, 2 WALLS, 3 LAYERS on the floor, made all the difference. Rigidity is now double.
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
lovely detail too thin
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld