Carrie movie poster fridge magnet
Boost
22
12
8
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
3.3 h
1 plate
Open in Bambu Studio
Boost
22
12
8
0
7
13
Released
Description
Carrie movie poster fridge magnet.
Measuring 65mm wide by 95mm high by 5mm deep
4 colour AMS print, using black, red, white and lemon yellow.
This needs 4x 8mm diameter by 2mm deep magnets, the magnets push into the model after printing, no need to pause.
NOTE - The magnets are designed to be a tight fit. The best way to insert them is to line up a magnet with a hole then place the model on a hard flat surface facing up, with the magnet on the hard surface, then press down firmly on the model. The magnet will snap into place. Repeat for each magnet.
Comment & Rating (8)
All
Print Profile
0.08mm layer, 2 walls, 15% infill
Great design but the red background is a little rough in areas. As you can see in photo.
The designer has replied
0
Reply
Sorry it didn't print correctly for you.. That's not printed correctly as my test print is totally smooth.. Maybe your red filament is bad somehow 😕
0
Reply
Here's a close up of my teat print for reference
0
Reply
Replying to @crabstiks
I will try reprinting. @crabsiks do you print on a hot plate or cold?
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Another classic!
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld