Sorry, aber für den Kontakt zur Platte und die Einstellung des Druckers ist jeder selber verantwortlich. Das liegt nie am Modell.

The model may be perfect for resin, but with FDM you need a lot of support in unnecessary places. Especially between the rear paws and the rear belly area this was rather suboptimal and very difficult to remove without damaging the model. The best way to get it really clean would be to print with a different support material. Alternatively, the modeling could be clearly optimized for FDM, where, for example, the paws and the rear part are basically flat and don't need any support underneath. I also used the predefined profile, which meant that the alignment was not up to me :).