Search models, users, collections, and posts
Soap Holder
IP Report
Print Profile(1)
0.24mm layer, 2 walls, 15% infill
4.5 h
2 plates
Open in Bambu Studio
Boost
83
180
16
16
220
135
Released
Description
The Dish and Topdish are designed to fit together. Dish2 and Topdish2 hold a full size soap bar. Dish1 and Topdish1 is just a smaller version of the same design. Dish1 may not fit all soap bars, but most soap designs would probably work. No supports on any models, the "Topdishes" are hard to print, please have patience with your bed level calibration. Good Luck!
Orientation will need to be adjusted. Rotate the models to match the last picture. Thanks!
Category: Tool Holders & Boxes
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (16)