Strawberry Hanging Planter

Copyright Claim

Strawberry Hanging Planter

Boost
35
73
2

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
16 h
2 plates
4.0(2)

Open in Bambu Studio
Boost
35
73
2
5
80
24
Released

Description

A hanging planter that can also be set on the ground or windowsill. I use it for strawberries and hang it from my gazebo. The bottom snaps in. Its pretty tight but I have made 3 and they all snap in it just takes some force.

Comment & Rating (2)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
Strength Issue:It was too small for the strawberries I could buy here so check your strawberry sizes before printing and the bottom plate snaps the plugs to hold it to the tower, used moist ish petg first and all snapped off, new petg only 3 snapped off, think there should be a new way of locking them together. I didn't get to use it cuz too big strawberries but I'll use it for some other hanging plants in the future. (I might post pictures in the future)
1
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more