Louver for exhaust vent
Copyright Claim
Louver for exhaust vent
Boost
0
1
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
32 min
1 plate
Open in Bambu Studio
Boost
0
1
3
0
3
2
Released
Description
Summary
Replacement louver for exhaust vent. In my case this was for my dryer vent, but I have similar ones for bathroom fans too.
Print Settings
Printer: Bambu Lab X1C
Supports: No
Resolution: 0.2
Notes:
I found that printing this vertically on its side, as in the attached print profile, works the best. If you print it flat it needs supports that do not detach well. Printed in PETG for outdoor use.
If I saved you a trip to Home depot feel free to pop a donation in the beer jar
Comment & Rating (3)
All
The print profile is no longer public
Strength Issue
Support Issue
The designer has replied
0
Reply
can you elaborate? I did not need supports when I printed it. As far as strength goes, it is working just fine in my vent.
0
Reply
Replying to @MarksMakerSpace
Actually I just tried my profile and it looks like the rotated version did not get published. I have deleted the old one and uploaded the correct version. The orientation shown in the picture where it is standing up will work much better.
(Edited)0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld