Thanks to Pinky Ponky Design for the original model.

I made this remix for increased comfort, and to allow your fingers to come closer together, so it's easier to keep hold of whatever you're smoking.

I also made the finger holes slightly larger, as the original was a bit tricky to take off. Apparrently I have chunky fingers 🤷🏻 🤣

Due to less surface area touching the print bed, I recommend printing this version with a brim and with supports for the bottom arch (included in print profile).

A little clean up will be needed on the bottom, to remove sharp edges and the rough arches. A few backwards scrapes with a sharp knife, and a quick rub with some sand paper, will make it feel much nicer in the hand.

I have included the .step file so that it's easier for anyone to edit, but be warned, it's an absolute sh*t show in there, due to starting with an .stl file.

EDIT: I have also made a single ring version: https://makerworld.com/en/models/417314#profileId-319684

CAUTION: It seems not all Clippers are created equal. Some are a tiny bit thicker than others (maybe just the painted ones?), and are a bas*ard to remove, so I have included a removal tool 👍🏻