Print Profile(4)
AMS, 0.16mm layer, 2 walls, 15% infill
Designer
2.8 h
2 plates
0.16mm layer, 2 walls, 15% infill
Designer
2.4 h
1 plate
AMS2, 0.16mm layer, 2 walls, 15% infill
Designer
3.4 h
2 plates
PAUSE, 0.16mm layer, 2 walls, 15% infill
Designer
2.7 h
2 plates
Boost
7
7
16
1
16
18
Released
Description
Apple Watch Charging Dock
Compatible with Apple charger. I’ve used the Apple Watch series 1 second generation 38 mm model as a reference.
A two-part model that snaps together well. Spring-loaded mount for the charger. Cord strain relief at the bottom. Storage space at the top for AirPods or jewelry.
Easy to print
The model has several printing profiles. One color, two colors with pause and two colors with AMS.
Support only in the round area of the charger. Printing profiles contain several modifiers to surfaces and support blockers.
Comment & Rating (16)
All
so have to say this it a great looking print but I’m afraid that I can’t use it as I don’t want to force my cable in the tight curves and on that bend. I think if it was a little taller for the cable to run smoother then this would be a big hit :)
The designer has replied
1
Reply
Thank you for the comment! I thought the same myself, but it didn't bother me before. Now that you're commenting on it, you're absolutely right and I'll change the design a bit, because yes, the cable stays well with a gentler bend. Thanks!!
1
Reply
Replying to @Jurdis
thats great :) cant wait to print it again :)
2
Reply
Boosted
Print Profile
AMS, 0.16mm layer, 2 walls, 15% infill
really like the design. thanks for sharing!
The designer has replied
1
Reply
Thank you and thank you for sharing the photo. Looks great! 😊
0
Reply
Updated cable groove. The strain relief is a little smoother now, but the cable is no longer on such a hard bend. I also added more room for the cable to bend upwards.
(Edited)
1
Reply
lovely :) thank you soo much cant wait to print it again :)
1
Reply
Boosted
Print Profile
AMS2, 0.16mm layer, 2 walls, 15% infill
thanks for sharing!
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
when you open the dock at the lower side, you have space to store the cable to adjust the cable length.
The designer has replied
1
Reply
A very good idea! Thank you! I'll have to think about this more. As if strain relief is in the same feature.
0
Reply
Replying to @Jurdis
I used a cutter after printing to open it - there is now place enough for a small cableroll - thanks for the model!
0
Reply
Replying to @3d.ruprecht
the strain relief still works, the Place is behind.
0
Reply
Print Profile
AMS, 0.16mm layer, 2 walls, 15% infill
love it!
The designer has replied
0
Reply
Thanks!
0
Reply
Print Profile
AMS, 0.16mm layer, 2 walls, 15% infill
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution
© 2024 MakerWorld