Search models, users, collections, and posts
Soap dish
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
1.4 h
1 plate
a1mini - 0.2mm layer, 2 walls, 15% infill
Designer
1.7 h
1 plate
Open in Bambu Studio
Boost
16
38
10
4
46
34
Released
Description
Mathematically designed soap dish! Fully configurable and available in several sizes
- the tops are lower in the middle, so the soap doesnt slide off
- the bottom trenches are higher in the middle, so water flows off to both sides
Customizing
You can customize this soap dish, just play with the values!
Printing
Print vertically. There will be a small line to connect the individual wiggles to ensure the print sticks to the print bed. Remove the line after printing.
Use the “noPrintSupport” versions to print without that line in case your adhesion is good.
Thanks
The OpenSCAD “plot function” used to mathematically define this soap dish was created by Ryan A. Colyer. Thanks Ryan! It is public domain (CC0).
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (10)