Mathematically designed soap dish! Fully configurable and available in several sizes

• the tops are lower in the middle, so the soap doesnt slide off
• the bottom trenches are higher in the middle, so water flows off to both sides

Customizing

You can customize this soap dish, just play with the values!

Printing

Print vertically. There will be a small line to connect the individual wiggles to ensure the print sticks to the print bed. Remove the line after printing.

Use the “noPrintSupport” versions to print without that line in case your adhesion is good.

Thanks

The OpenSCAD “plot function” used to mathematically define this soap dish was created by Ryan A. Colyer. Thanks Ryan! It is public domain (CC0).