Model

“Stabilize your rear deflectors. Watch for enemy fighters.”

3D print your own Star Wars Outland Tie Fighter (Moff Gideon´s) starship made from 3:1 scale replica of popular toy bricks.

Printing Guide

It is recommended to use the print profile I have provided to print this model. I can't guarantee that you will achieve the same success I have, but after several test prints and trial and error, I know this to work. I also recommend printing on a smooth surface PEI plate so your pieces are not textured.

Filament

The print profile is separated by color on each plate. You can use whatever filament you have on hand, but I used:

• PLA SUNLU Black
• PLA ESUN GREY

Print Settings

The print profile is set up to print two wall loops and 10% infill on gyroid , however you can tweak to your liking.

Supports

Again, I recommend the settings I have in the Print Profile. Most parts can be printed without supports, as the Bambu bridges the pieces very well, but the ones that need them are already set up to be supported and also easily removable.

Assembly

Look at the picture below to assemble. Pretty simple. Some parts fit great some are tight and some are loose, but overall it holds together