Cricut Vinyl Rack
Copyright Claim
Cricut Vinyl Rack
Boost
6
13
1
Print Profile(1)
0.24mm layer, 2 walls, 15% infill
Designer
5.9 h
1 plate
Open in Bambu Studio
Boost
6
13
1
0
10
8
Released
Description
My wife asked for a wall-mounted vinyl rack for her Cricut machine. Here it is. I had to scale it down 10 percent from the original size to fit the Bambu print bed, so they're a bit of a tight fit. I took the cardboard out to make the rolls a bit smaller and it works fine. The wife is happy now, enjoy!
Comment & Rating (1)
All
Print Profile
0.24mm layer, 2 walls, 15% infill
(Edited)
Support Issue:the print turned out pretty rough with these settings. and by the time it got to printing the top edges, it was quite wobbly. not only that but half of the rolls don’t even fit!
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution
© 2024 MakerWorld