Duct Adapter
Copyright Claim
Duct Adapter
Boost
5
12
6
Print Profile(1)
0.2mm layer, 3 walls, 20% infill
Designer
1.6 h
1 plate
Boost
5
12
6
0
29
24
Released
Description
3 to 4inch dryer duct adapter. I printed mine from nylon as an experiment using string trimmer line. It was meant to be used with one of those chinese diesel heaters typically used for campers or overlanding rigs. If it's not going to be exposed to high heat, PLA or PETG would be more than adequate.
Comment & Rating (6)
All
Print Profile
0.2mm layer, 3 walls, 20% infill
nicht zu empfehlen, passt nicht auf Spule drauf
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld