Hueforge Dog
Hueforge Dog
Boost
12
10
6
Print Profile(2)
0.08mm layer, 2 walls, 100% infill
Designer
3.8 h
1 plate
0.08mm layer, 2 walls, 100% infill
3.8 h
1 plate
Boost
12
10
6
0
41
15
Released
Description
An original piece of canine artwork (based on my dog) and turned into a hueforge piece of artwork.
Layers should be in the file but otherwise here are the changes:
Black until 17
Red or Blue until 24
Yellow until 30
White thereafter
Comment & Rating (6)
All
Print Profile
0.08mm layer, 2 walls, 100% infill
Came out really well with similar colours but not quite the same and I had to adjust the layer height to get it similar to your image
Black to 8
Red to 18
Silk Lime to 30
White the rest
(Edited)
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
printed on X1C, used orange instead of red but didn't come out as nice as the OP's one did, maybe my filaments are old (Prima Value PLA), the photo (cover) where it really looks nice was scanned in 1200dpi bed scanner, the rest just photo on phone, the “scanned” one WOW looks really nice, then again, from a few feet away it does look nice (this is my first HF experience), thanks OP for the design though
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
loved it. adjusted layers for a second print
0
Reply
Is that a Vizsla?
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoDerivativesRelated Models
© 2024 MakerWorld