Because my Prusa sits on a paver, I could not use existing spool holders. Decided to design my own.

Just print two and put then on each side of the wooden 'rail'. Holds a cutdown broomstick up to 29mm in diameter. Made screwholes for M6 screws if you want to secure it to the broom or rail.

Supports aren't really needed but you can add them if you're not feeling too lucky.

Version 1.0
- Initial version

Version 1.1
- Moved the screw hole up a bit so it's more centered to the rail
- Made the entire part a bit smaller so it prints faster