**Update:

I uploaded a new profile with reduced number of colors and body and head as single pieces.

Quicker to print.

To finish the work you could use painting to give a lighter shade to the belly fur and the bottom part of the head :-)

Takes half of the time than the full color and you can use just 4 colors.

*The tale continues…

More figures of the series are available on our Patreon Page… www.patreon.com/MixnBits

well, we present you the star of the tale…

Scrat, in love!

But in love with who? or better, with what…

You know him, the acorn is its obsession!

INFO

This print takes some hours (if you decide to go for the full color version is 20 hours more or less) , some DIY skills, and some glue.

As usual there will be to remove supports ( I went for tree slim but you can use organic tree if you prefer, but then swap again when you print the teeth as organic tree doesn't put any supports in them and they are needed).

The pink circles that go around the eyes must be glued to the round pieces (eyelids)

For the rest glue what you feel not steady. The figure has a delicate balance, once the big tail is put it can stand only if you put the head as the tail is pretty heavy.

No need to glue the eyes if you keep the figure on a shelf…so in case we decide to add some new design you can swap them.

We had some ideas for other expressions :-D

As usual: Enjoy printing!