Darts holder, 4 sets plus spares, optional wall mount
Copyright Claim
Darts holder, 4 sets plus spares, optional wall mount
Boost
8
14
11
Print Profile(2)
wallmount version: 0.24mm layer, 2 walls, 15% infill
Designer
2.1 h
1 plate
Non-wallmount version: 0.24mm layer, 2 walls, 15% infill
Designer
1.7 h
1 plate
Open in Bambu Studio
Boost
8
14
11
0
32
34
Released
Description
The darts holder is very handy, holding four sets of darts, with space for spare flights, shafts and a sharpener. There are two versions: wall mount and not. The wall mount version prints-in-place with a small plate to attach to the wall. The basic version can be attached with double stick tape, or just rely on gravity.
Nothing special for printing …
https://makerworld.com/en/models/41404 is a smaller version that holds 2 sets of darts, plus plenty of room for spares.
Useless fact: the Andy Capp flights shown in the photos go back to my Navy days, more than 40 years old!
Designed in OpenSCAD.
Comment & Rating (11)
All
Print Profile
Non-wallmount version: 0.24mm layer, 2 walls, 15% infill
1
Reply
printer on P1S came out very well used PC
0
Reply
Print Profile
wallmount version: 0.24mm layer, 2 walls, 15% infill
1
Reply
Print Profile
wallmount version: 0.24mm layer, 2 walls, 15% infill
1
Reply
Print Profile
Non-wallmount version: 0.24mm layer, 2 walls, 15% infill
1
Reply
Print Profile
wallmount version: 0.24mm layer, 2 walls, 15% infill
1
Reply
Print Profile
wallmount version: 0.24mm layer, 2 walls, 15% infill
1
Reply
Print Profile
wallmount version: 0.24mm layer, 2 walls, 15% infill
1
Reply
Print Profile
wallmount version: 0.24mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Non-wallmount version: 0.24mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld