Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2 h
1 plate
Open in Bambu Studio
Boost
136
302
16
8
455
205
Released
Description
Although this model may seem hard, it really isn't. The best way I found to print this was on its side with the base pairs being perpendicular to the bed and the strands parallel. Because the base pairs are small print with a small nozzel (around 0.4mm) an printing with tree supports is a must. Feel free to send me suggestions and questions as well I don't mind if you make a remix of the model.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (16)