HAPPY HALLOWEEN!

Giant marquee sign just in time for spooky season.

Broken up into “backs" and “inners”, this sign can be downloaded and printed as is.

Each letter of the sign will have its corresponding back and inner piece. The inner pieces fit TIGHT so you may need to use a deburring tool on them after pulling them off the bed, especially if you use a raft.

The back pieces are cut so they only need to be superglued together and should fit perfectly and no stand is required. The whole sign sits upright vertically on its own.

Each back piece is also hollow and has a hole leading to the next one. This is where you should run your RGB strip light (any type should work), then slot in the inner pieces on top once the lighting is in place.

There is one exit hole for the lighting on the far bottom right “N” in the “HALLOWEEN” – use this to connect to you power source if you are using a standard RGB battery or outlet strip of lights.

The example images for my own sign are printed in black and white (see last image) and is alos upscaled to 200%.

Totally modular, so feel free to scale up even more! the 200% was good for about 2 backs or 2 inners at a time on the P1P/X1C beds.

Hit me up with any questions you might have!

Buy me a coffee!