DeWalt DCBL722 Leafblower Concentrator Nozzle
Copyright Claim
DeWalt DCBL722 Leafblower Concentrator Nozzle
Boost
10
21
7
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
3.8 h
1 plate
Open in Bambu Studio
Boost
10
21
7
3
31
25
Released
Description
I wanted a DeWalt OEM look-and-feel concentrator nozzle that excels better at planar, directional air for things like
- leaf-blowing…
- snow removal from cars/driveways
- dust removal from garage (especially sawdust)
and it's much better to have a duckbill nozzle than a round/circular one from DeWalt.
I looked into nozzle by LCSteve, but did not print it - I wanted more an OEM clip look & feel.
Created this one from scratch, dimensioning off from the OEM nozzle.
Print:
- Nozzle down (flat side down - better adhesion)
- 0.4mm nozzle, 0.2mm layers
- 4 perimter
- 10% infill
- tree support
- brim
Comment & Rating (7)
All
You can print this upside down and turn off supports. 😉
The designer has replied
1
Reply
good point!
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
air seal leaking for direction think a ring inside to seal would be a great addition .
The designer has replied
0
Reply
that doesn't make any sense to me... air seal? this is a leaf blower, not an airtight tube
0
Reply
Boosted
Print Profile
0.2mm layer, 6 walls, 25% infill
Perfect thanks!
0
Reply
Boosted
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld