AirPods Pro 2 carrying case by Mr_121

Mr_121

Tools>Other Tools

Print Profile(4)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

1.5mm retraction to reduce strings.

Designer

1.8 h

1 plate

5.0(2)

case with charging port. 0.2mm layer, 3 walls, 15% infill

Designer

1.8 h

1 plate

5.0(1)

0.2mm layer, 3 walls, 15% infill

Designer

1.9 h

1 plate

4.3(4)

0.2mm layer, 3 walls, 15% infill, A1 mini

1.9 h

1 plate

5.0(1)

Open in Bambu Studio

Boost

Released

Description

I normally don't use a case for my AirPods Pro, but they can get scratched during long-distance travel. This case is the solution!

Printed in TPU, the case features a full closure protection with no gap at lid openning area. It's designed in one piece and can be printed without any support.

To ensure a snug fit and easy removal of the AirPods, I've made the internal space slightly larger and added ridges. These ridges, along with the extra space, also offer some shock absorption.

If you like this design, please rate it or leave a comment, thanks!

Comment & Rating (16)

@donnay

this looks like a great design. when I print in BBL TPU 95A HF it comes out quite stringy. any suggestions to get a cleaner print?

The designer has replied

@curler.canvas0w

your filament is way too wet. Many types of filaments need to be dried before use. It’s worth to get a filament dryer.

(Edited)

@donnay

Replying to @curler.canvas0w :

Even after heating my TPU to 55 degrees C for 12 hours & @ 18% Relative Humidity - it is still stringy, :( Maybe speed?

@curler.canvas0w

Replying to @donnay :

print speed normally don’t contribute to stringing to my knowledge. if print TPU too fast it may clog the nozzle due to the softness of the material.

@donnay

Print Profile

0.2mm layer, 3 walls, 15% infill

Other Issues:the speed set in the print profile is too fast! even after fully drying the filament for 12 hours down to 18% Relative Humidity it prints out with lots of strings, and over extruded.