Summary

Filament roller, will fit the Rubbermaid 21-cup container. Uses four 608ZZ bearings, should work fine without screws or anything. I added M3 bolts and nuts myself for extra strength, but it should not need it if you print the bridges with high infil

Print Settings

Rafts:

                                            Supports:                      
No

Resolution:

0.2

                                            Infill:                      
15% / 100%

Filament:

Generic PLA

Comment & Rating (9)

@Jendapce

Print Profile

0.2mm layer, 2 walls, 10% infill

A very good single coil stand. I recommend grinding the holes a little before pressing the bearings and heating them a little while pressing.

@q6hm47fzq4

Print Profile

0.2mm layer, 2 walls, 10% infill

works great, bearings fit tight - used a rubber band to hold the whole thing together

@RynosaurusRex

Print Profile

0.2mm layer, 2 walls, 10% infill

printed good

@branchedout

Printed very nicely and bearings fit into the roller bits, however my particular bearings fit very loosely onto the roller stands. Will jimmy something to make it stiffer. There is about a .1mm gap inbetween them, will drum up a .1mm spacer and see if that works! Edit: Nope, BambuSlicer has a bit of a hissyfit.

(Edited)