Sand and Rock Classifier Sieve Stack
Copyright Claim
Sand and Rock Classifier Sieve Stack
Boost
10
21
4
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
11.7 h
5 plates
Boost
10
21
4
2
47
32
Released
Description
I made these sieves to separate out sand so that I could used mixed gravel for making TTRPG terrain
Comment & Rating (4)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
very cool design. Did get a few strange lines on the exterior around the side markings, but still looks great and will function well.
0
Reply
That's the seam, not the model. There's an option in your slicer to randomize the beginning and end of each layer so it doesn't do that!
0
Reply
can you just separate them all into their own plate and describe which is which size? I only need a couple and the double plates arent close in hole size
3
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld