Adjustable graphic card holder bracket Geforce RTX
Copyright Claim
Adjustable graphic card holder bracket Geforce RTX
Boost
56
62
9
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
1.4 h
1 plate
Less Supports + Stronger - 0.2mm layer, 3 walls, 10% infill
1.6 h
1 plate
Boost
56
62
9
5
156
86
Released
Description
- Print per object is set in the profile.
- A support blocker is set on the threaded rod.
- The RTX needs the support, it takes 2 minutes to get the inside out nicely. You will need a large screwdriver, a small screwdriver and a small pair of pliers. Wait until the object cools down and be careful!
- The RTXis rotated 180 degrees on the Y axis, so the bottom becomes the front of the object, and so you don't see the seam in the middle of the rod as it is on the back.
- I have tested it, I have printed several pieces.
- Adjustable between 85 and 126 mm.
- The model in the picture is made of Bambulab green filament.
- If you like it, please give it a like and a drop a review if you printed it.
Comment & Rating (9)
All
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Szuper modell, könnyen nyomtatható!
Perfect!
The designer has replied
0
Reply
螺纹打印失败，请问你是怎么设置的？
0
Reply
Replying to @user_2906522833
Google translate: 我已经使用这些设置打印了很多次。但不知道你用的是什么类型的灯丝。 配置文件包含这些设置，只有文件化才需要设置。
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
tres bien mes inpeu haut même au minimum
The designer has replied
0
Reply
wow
0
Reply
Print Profile
Less Supports + Stronger - 0.2mm layer, 3 walls, 10% infill
Beautiful print. Still not sure what the little nub is for other than extending the length of the screw. I didn't end up needing it. Screw is extremely tight which obviously in this case is perfect and it's holding my 4090 with pride in my Lian Li Case. I had to use some needle nose plyers to tighten the screw to where I needed.
2
Reply
Boosted
Print Profile
Less Supports + Stronger - 0.2mm layer, 3 walls, 10% infill
Perfect Print and really nice model! thank you
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Less Supports + Stronger - 0.2mm layer, 3 walls, 10% infill
0
Reply
No more
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
© 2024 MakerWorld