The Goonies movie poster fridge magnet
Boost
67
76
21
Print Profile(2)
0.08mm layer, 2 walls, 15% infill
Designer
3.5 h
1 plate
French version - 0.08mm layer, 2 walls, 15% infill
3.5 h
1 plate
Boost
67
76
21
5
59
32
Released
Description
The Goonies movie poster fridge magnet.
4 colour AMS print, using black, lemon yellow, white and orange.
This needs 4x 8mm diameter by 2mm deep magnets, the magnets push into the model after printing, no need to pause.
NOTE - The magnets are designed to be a tight fit. The best way to insert them is to line up a magnet with a hole then place the model on a hard flat surface facing up, with the magnet on the hard surface, then press down firmly on the model. The magnet will snap into place. Repeat for each magnet.
Comment & Rating (21)
All
Boosted
Print Profile
0.08mm layer, 2 walls, 15% infill
It looks fantastic!
The designer has replied
1
Reply
Looks great! Thank you for the rating, I'm glad you like the model 😊
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
I'm a big fan, so a big thank you!
French version added !
The designer has replied
1
Reply
Nice job again Allan... Well done
0
Reply
you make some great stuff
(Edited)
The designer has replied
1
Reply
Aww thank you! And I really appreciate the downloads, ratings and comments 😊
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Thanks for the rating 😊
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Turned out really well as all your models. I printed 3 at a time and flipped the infill to gyroid. I've done the same with all these excellent models. Would love to see an original Halloween, Gremlins and Howard the Duck in the future if you are taking suggestions :).
The designer has replied
1
Reply
Thanks, I only just realised I had used grid infill... Future models will use gyroid!
Some posters I can't do as they need more than 4 colours to look right... Which is why not all posters are the originals and remixes.. I am expecting a 2nd ams so soon I'll be able to do 8 colours... However it will mean that you'll need 2 AMS units to print them 🤷🏼♂️
0
Reply
Replying to @crabstiks
I have 2 AMSes so happy to test anything you design.
(Edited)1
Reply
Replying to @mmarcoux66
Great! I'm looking forward to ams number 2 arriving
0
Reply
Clean print. Took it a step further and used epoxy to give a nice clean shine.
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Awesome!
The designer has replied
0
Reply
Thanks, I'm glad you like the print
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Mega
0
Reply
Boosted
Great job, this looks amazing.
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld