Print Profile(1)
0.2mm layer, 3 walls, 100% infill
Designer
6.6 h
2 plates
Boost
12
19
7
0
18
20
Released
Description
This little lightbox is the perfect way to let people know it's safe to trick or treat at your home! Just put this in the window, and get your candy ready!
Only 3 colours are needed, print the “box” at 1.06 flow rate, and then the backplate at your standard flow rate.
Print at 0.2mm layer height for the box, and any height for the backplate.
Comment & Rating (7)
All
The print profile is no longer public
Looks amazing with a backlight. I used a tea light
The designer has replied
1
Reply
I'm so glad that you like it! Thank you so much for the feedback!
(Edited)1
Reply
what light was used to light it?
The designer has replied
0
Reply
Just a standard 5050 led strip. It may need to be rolled slightly to fit through the wire hole, but it let's less light escape that way. 😊
0
Reply
nope didn’t work, had to melt a bigger hole
0
Reply
Replying to @RaisingTheBARDe
If you're using the waterproof lights, then it may have been too tight. I'll edit the model and add a version with a larger hole. :)
0
Reply
Print Profile
0.2mm layer, 3 walls, 100% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld