Search models, users, collections, and posts
Flow calibration
IP Report
Print Profile(0)
Add the first print profile to earn points
Boost
3
7
0
0
54
4
Released
Description
Model used to calibrate flow directly on Slicer
set 100% flow before print, after that check the thickness of the wall and calculate:
(0.4*thickness)/100
the answer will be the flow your are looking for.
Print it again to check.
Hint: let first layer flow the same or 100%. using the formula I correct the flow and got right thickness printed, but had problems with plate adhesion.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)