*** 2024-05-03 UPDATE ***

Main Body STL updated, wall generation settings are as desired or what works best for you.

0.2mm layer height is still required.

************************

Nice little joint keeper that can also keep you entertained, stores one joint. The safety cap can easily be removed or flicked off, there is also a spot at the bottom to store the cap while using the lighter.

Fits classic BIC lighters and the doob tube is 12mm ⌀ x 75mm depth. Remove stickers from lighter for best fit.

PRINT SETTINGS:

0.4mm nozzle

IMPORTANT: 0.2mm layer height for initial and all other layers. This is needed for the floating cantilever inside the model to separate.

2 walls minimum

Classic wall generation for main body (Make sure to adjust gap fill), Arachne for caps.

10% infill of your choice

Paint infill on long edge or try scarf joints.

No supports needed

Videos:

Alternative method to snap the safety cap off.