Airless Ball that bounces V2 by Tim

Tim

Toys & Games>Other Toys & Games

GIF

Print Profile(4)

All

P1S

P1P

X1 Carbon

X1E

PLA, newest V, w support 0.15mm layer, 2 walls, 15% infill

Designer

36 min

1 plate

4.9(10)

PLA W/Supports NEW V 0.2mm layer, 2 walls, 15% infill

36 min

1 plate

PETG W/Supports NEW V (Recommended) 0.2mm layer 15% infill

47 min

1 plate

TPU W/Supports NEW V 0.2mm layer, 2 walls, 15% infill

49 min

1 plate

Boost

104

Released

Description

Yes, this ball really bounces like a rubber ball!
PLA was used in this print.

Try it yourself, and have fun with it.

If you like this model, please consider gifting me your Boost. Thanks

Comment & Rating (31)

@Fin3dPrinting

I tested the new version in PETG and TPU the new version is really good! I will add the TPU and update my existing profiles with the new version

The designer has replied

@Tim04

Hey Fin3dPrinting, Thanks so much for printing it in TPU, does it bounce properly ?

@Fin3dPrinting

Replying to @Tim04 :

it does not bounce as high but it is basically indistructable. I also just updated my print profiles.

@Tim04

Replying to @Fin3dPrinting :

Okay, thanks a lot. You help us small creators improve our prints :)

@Fin3dPrinting

Print Profile

PLA, newest V, w support 0.15mm layer, 2 walls, 15% infill

I made this in PETG it bounces really well until you throw it really hard it will crack then finally it will break in half. Really good overall! i will add print profiles for PLA and PETG with supports already added. might be better if you made it just a a little bit thicker

The designer has replied

@Tim04

Hey Fin3dPrinting, First thanks a lot for testing and uploading your print profile. Thanks also for the gifted points :). I thickend the walls, and made the holes smaller. That way it should be more sturdy. And yes, i tested it, no cracks or breaking, even when throwing it really hard! I uploaded the new print profile....

(Edited)