Before you print:

• This model is fully parametric (you can modify it to your liking). 
• You may need a brim on the edges of the spinner body
• Please refer to the BOM for additional parts

Bill Of Materials

Printing Tips

• High infill will increase the inertia of the part (if your crazy, tungsten PETG is an option)
• Supports are required (you should dial in your settings with low infill test prints)
• Warping should be avoided 
• Use a “fine” profile for best ergonomics (0.08mm layer Height not required)

Assembly

1. Once you have all the parts ready, you can press the bearings into the body (flange outside)
   Note: you may need glue if the bearings are loose
2. you may press in the bearing inserts (may require force)

Safety precautions

• This fidget spinner shall never be spun with any power tool or air hose
• Rotational speed should never exceed 3000 RPM 
• Keep away from face and eyes
• Use Common sense

Disclaimer & Additional Information

• This model was created with education software, it is free to use, distribute, and modify but cannot be used commercially 
• Remixes of this model are welcome