Gaara by Garuda3D

Garuda3D

Generative 3D Model>Hueforge & Lithophane

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.08mm layer, 1 walls, 100% infill

Designer

2.7 h

1 plate

5.0(2)

Open in Bambu Studio

Boost

Released

Description

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Red
At layer #12 (1.04mm) swap to Yellow
At layer #18 (1.52mm) swap to Jade White for the rest.

Comment & Rating (3)

@hoemalone

Print Profile

0.08mm layer, 1 walls, 100% infill

This print is great! An amazing design and really nicely made Hueforge piece. Wverything on the designers end is amazing! Thank you for making this awesome Naruto piece! I swapped yellow for brown on my print, I don’t love that color swap’s results, but that’s my fault not the prints. (Just ran out of yellow and thought it might look good).

The designer has replied

@Demirev

Thank you! ^^ I see what your idea was here buddy and it's not bad at all. I will make for sure few brown color Gaara designs later on. Have a great day and thanks for the review