Whiskey Ice Ball Tray
Whiskey Ice Ball Tray
Boost
37
73
11
Print Profile(1)
0.2mm layer, 2 walls, 20% infill
Designer
3.4 h
1 plate
Open in Bambu Studio
Boost
37
73
11
3
109
68
Released
Description
Sphere ice ball mold for Whiskey/bourbon or other alchohol drinks. Makes spheres with a dimension of 55mm/ 2 inch, can be reshaped for smaller or larger size of spheres. Fill the cup untill the line showed in the pictures and insert the top tray. Cooling can take 3-4 hours depending on temperature. The holes serves as an overflow valve and to push the sphere out. Run warm water over the tray to help seperate the parts after cooling.
Enjoy printing,
PrintTech101
Comment & Rating (11)
All
is this OK to make out of PLA or use a food safe filament?
The designer has replied
1
Reply
Pla works, and is food friendly normally. But check your specific type of filament just to be sure.
0
Reply
In most cases PLA isn't food safe bc of additives
1
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
great print. had to run warm water and wait some time, and fill line might not be tall enough, but with some practice I’ll get it to form a full ball. was about 85% a complete sphere on first try at line. thanks for the profile/model
2
Reply
WORKS GOOD THANKS
1
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
1
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 20% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld