Sunlu Filament Spool Centre Weight Tube
Copyright Claim
Sunlu Filament Spool Centre Weight Tube
Boost
9
13
14
Print Profile(1)
0.20mm layer, 2 walls, 15% infill
Designer
2 h
1 plate
Boost
9
13
14
0
63
52
Released
Description
A super-simple and easy to print container which fits perfectly into the centre of a Sunlu spool. No fancy screw system or pointless contraptions that complicate the print.
Ideal for when the filament is running low and the AMS struggles to feed it.
Add whatever you like to the container. (I just use some stones from my garden)
Added an air hole and dimples based on feedback.
Comment & Rating (14)
All
Print Profile
0.20mm layer, 2 walls, 15% infill
great fit for Sunlu spools however I filled it with marbles instead of batteries and the lid isn’t tight enough to stay on without tape or another form of adhesive to keep it on.
The designer has replied
0
Reply
It doesn't matter that the lid isn't tight. I have designed it to be wider than the AMS compartment so when it separates, it will still stay together.
0
Reply
Print Profile
0.20mm layer, 2 walls, 15% infill
really nice and tight fit!
0
Reply
Comes together nicely but bit to loose and will separate
The designer has replied
0
Reply
Works fine for me!
0
Reply
Does this fit together with a pressure fit? Seems like it would wear down over time opening and closing it
0
Reply
Print Profile
0.20mm layer, 2 walls, 15% infill
Strength Issue
The designer has replied
0
Reply
Strength issue in what way please? I'm always looking to improve my designs.
0
Reply
Print Profile
0.20mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.20mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.20mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.20mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.20mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld