A book that you can use to store your dice, Halloween candy or other stuff. Blank cover without the skull included.
Can store approximately six sets of polyhedral dice.
See my recommended print settings below!
 

Height: 175mm / 7"
Width: 125mm / 5"
Thickness: 37mm (internal 30mm) / 1.5" (internal 1.2")

I can adjust the size on request.

Best regards,
Jonas


COVER:
No supports needed
0.2mm layer height
2 walls
10% infill

To get a leathery look on the cover:
Enable Fuzzy skin

Fuzzy skin Point Distance 0.4mm
Fuzzy skin Thickness 0.1mm (max)

(Fuzzy settings are the same in most slicers but results may vary with printer model and outer wall print speed. Slower is better)

 

PAGES:
No supports needed
0.24mm layer height
3 Walls
10% infill