This is a simple stand for the excellent Moon Globe Lamp model by TBone_427120 https://makerworld.com/en/models/31191?from=search#profileId-27822

I printed the great Moon Globe lamp, which was originaly designed for the LED 001 kit, sold by Bambu.

I wanted to achieve two things - have the Moon a bit higher, and be abe to fit an ordinary lightbulb inside. This way, you can easily play with color temperature by changing the bulbs.

I used a simple black plastic E14 socket with two screw rings, which is attached to my stand. I did not use the E27 socket, because there might be a problem with some E27 bulbs not fitting into the opening on the bottom of the globe itself. E14 bulbs should be OK. All the electrical parts (E14 socket, E14 LED bulb, 3m long cable with a simple flip switch) were sourced from a local hardware store, and were in fact cheaper than the LED 001 kit.

The stand is designed to fit on a BambuLab A1 mini plate. I printed it upside down, using painted supports for the outer ring. Used snug support setting, no problems getting them off. Cleaning took just a couple of seconds. Printed on A1 mini in basic PLA black (local source), 0,4mm nozzle, using variable layer height (possibly overkill, but wanted to have the legs as smooth as possible). Printed without brim and had no bed adhesion issues. All the details are in the provided print profile.

Assembly is starightforward. Remove the supports on the top edge of the base. Connect the cable to the bulb socket, put the socket in the opening on the top of the base and secure it with screw rings from both sides. Insert the bulb of your choice. Put the whole thing into the lamp, it secures with a bayonet lock, same way as the original LED 001 base. It may need some support remains cleaning for both the base of the lamp, and the top of the stand in order to twist-lock easily.

The base is stable, 11 cm tall.

Hope you like it.

And once again - thanks to TBone_427120 for his amazing Moon Globe for LED Lamp 001 model.