Lamps that utilize purge into its own design. Just fill it with filament purge, add led lamp kit 001 and you have good lamp :)

I created three versions of this lamp.

With each new shape, I improved this lamp a little. 

I used clear PLA for this project.

Below are the changes I made

1. Square Lamp - this is the simplest of lamps. Wall 1 mm. Top loaded and covered with a lid.

2. Rounded lamp - Here I made loading from the bottom and a bottom cover that also holds the LED kit. Wall 1 mm.

3. Crystal lamp -The most complicated shape. Loaded from the bottom with a bottom lid. I used several cutouts for the cable in the lower cover, so you can choose which side of the crystal you like best and hide the cable at the back. I reduced the wall to 0.8 mm so the lamp is more transparent. I like this shape the most. It also performs very well without a filament load.

|

Have fun