Scream Wes Craven movie poster fridge magnet
Boost
62
60
19
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
3.6 h
1 plate
Open in Bambu Studio
Boost
62
60
19
2
67
42
Released
Description
Scream Wes Craven movie poster fridge magnet.
3 colour AMS print, using black, red and white.
This needs 4x 8mm diameter by 2mm deep magnets, the magnets push into the model after printing, no need to pause.
NOTE - The magnets are designed to be a tight fit. The best way to insert them is to line up a magnet with a hole then place the model on a hard flat surface facing up, with the magnet on the hard surface, then press down firmly on the model. The magnet will snap into place. Repeat for each magnet.
Comment & Rating (19)
All
Print Profile
0.08mm layer, 2 walls, 15% infill
Great print! Printed in bambu pla basic white, black, red.
I made some changes to minimise scale, purge and to support 8x3 magnets for the smaller scale.
1. Scaled to 50% X/Y
2. Added square negative modifier to reduce the height of text to minimise purge
3. Added cylinder negative modifier to support the same 8x3 magnets on scaled down model
The designer has replied
1
Reply
Nice job, looks good! And thanks for the rating, I appreciate it
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Looks great!
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Perfect !
Keep it up, it's great!!
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Thanks for the all the ratings! Much appreciated!
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
As always, amazing designs.
The designer has replied
1
Reply
Thank you! I appreciate it
0
Reply
Boosted
Print Profile
0.08mm layer, 2 walls, 15% infill
Excellent print
The designer has replied
1
Reply
Thank you for the rating, I'm glad you like the model
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Thanks for the rating 😊
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Thanks for the rating 😊
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld