可以有三种玩法：A、作为秘密容器直接玩；B、硅胶翻模后滴胶；C、硅胶翻模后热融

There are three ways to play: A, play directly as a secret container ; B. Silicone Mold and Resin Art; C. Silicone Mold and Casting

A、

B、简略步骤  Brief steps:

1)将方尖碑打印件放到模具外壁打印件里，可以用双面胶固定一下。模具外壁打印件可以用其他容器替代，能容纳硅胶就行。方尖碑打印件最好先打磨一下。
1) Place the printed obelisk and the wall together, and the double-sided tape is helpful. It's great if the obelisk is polished.

2)填充硅胶混合液（按厂家比例调配），没过打印件5mm以上。最好能够消泡
2) Fill the gaps with silicone mixture (according to the manufacturer's ratio). It’s needed to cover the obelisk more than 5mm. De-bubble will be a great help.

3)等硅胶固化以后，取出方尖碑打印件，必要时在方尖碑棱边处切开一道缝，这样比较容易取出，但不要切到底，要不后面就不好滴胶了。这样模具就做好了。
3) After the silicone has solidified, take out the printed parts. If necessary, cut a seam at the edge of the obelisk to make it easier out. But do not cut it along to the bottom, otherwise it will be difficult to Resin Art. Finally, the mold is ready.

4)按自己的想法在模具里填充一些东西，然后在模具有切缝的地方用橡皮筋固定好，要不滴胶会从缝里流出来。填充上滴胶混合液（按厂家比例调配）。
4) Fill the mold with some stuffs as your wish. Fix the mode with rubber bands, otherwise the resin will flow out from the seams. Fill with resin mixture (according to the manufacturer's ratio).

5)等滴胶固化后，取出滴胶成品。进行一些打磨抛光
5) After the resin has solidified, take out the resin. Perform some polishing.

Here is a great reference:

C、简略步骤  Brief steps:

1)同B的制作模具方法
1) The same way as B to make silicone mold
2)在模具里填充耗材，放入烤箱里加热融化。或者用热风枪吹融。
2) Fill the mold with filaments and heat them in the oven. Alternatively, use a hot air gun to melt them.
3)等耗材冷却后，取出成品
4)After the product has cooled down, take out the finished product

Here is a great reference: